Dhcpcd-6.8.2-armv7l: !!top!!

The daemon can also be run manually for debugging purposes:

On ARMv7l single-board computers, network interfaces (like eth0 or wlan0 ) can take a moment to initialize during boot. If dhcpcd fires up too quickly, it may fail to bind to the interface. dhcpcd-6.8.2-armv7l

# Run in foreground with debug output dhcpcd -d -f /etc/dhcpcd.conf eth0 The daemon can also be run manually for

If your network does not use IPv6 or you wish to disable it for any reason, you can add a single line to the global configuration or per-interface: dhcpcd-6.8.2-armv7l

Example installation command: