Essilor Kappa Error Codes ((exclusive)) -
Prevention is always better, and often far cheaper, than cure. Adhering to a regular maintenance schedule will keep your Kappa running smoothly and prevent many common error codes.
: Indicates a Lens Holder movement error . This often happens if the lens holder is stuck or obstructed.
Edging a lens that is too large, excessive feed pressure, or dull polishing/cutting wheels. Troubleshooting: Inspect and clean the cutting area.
The machine cannot be reset, even with the emergency stop button twisted out. All servos are disabled. essilor kappa error codes
: Commonly associated with motor errors (specifically grooving or drilling motors). It may be caused by debris in the socket or electrical current issues. E01, E02, E03
The machine stops abruptly during the roughing cycle, usually with a grinding noise change before the halt.
: Often related to a positioning motor error or communication issue with the assembly. Prevention is always better, and often far cheaper,
Access the edging chamber and locate the two flexible feeler arms.
Symptoms: lens slips during processing; vacuum alarm/code displayed. Immediate steps:
: The edger door is opening or closing too slowly, or failing to reach its fully open/closed position within the designated safety window. This is frequently triggered after replacing internal parts or if debris blocks the tracks. This often happens if the lens holder is stuck or obstructed
| Error Code Group | Maintenance Action | Frequency | |------------------|--------------------|------------| | E-01, E-12 (homing/tracing) | Clean optical encoders; lubricate guide rails (light oil). | Monthly | | E-03, E-50 (motor/servo) | Check wheel balance; clean cooling fan filters. | Quarterly | | E-07, E-27 (sensor/groove) | Calibrate block sensor with calibration lens. | Semi-annually | | E-14 (water pump) | Descale pump impeller; replace inlet hose. | Quarterly |
: Tracing table defect . This indicates a hardware failure in the tracer unit. General Troubleshooting Steps
Redo the operation; if it persists, re-calibrate the tracing table. Troubleshooting & Maintenance Tips Initial Checks