Verify that the cooling fins run vertically to optimize natural airflow.
For further information and technical support, refer to the following resources:
Restore power. A stable status light indicates correct phase sequence. Simulate a phase error (if safe) to verify the relay trips as expected. gmr-32b phase controller manual
Range: 0.0 to 60.0 seconds. Controls the ramp-up time of the voltage to protect loads from high inrush currents.
to signal status: Normal, Phase Loss, Reverse Phase, Overvoltage, and Undervoltage. Wide Application Range Verify that the cooling fins run vertically to
Proper installation and setup of the GMR-32B phase controller are crucial for ensuring safe and efficient operation. The following steps should be followed:
Proper wiring is critical for correct operation. Ensure the mains power is completely disconnected before making any connections. For a typical three-phase, three-wire (without neutral) system, the following applies. Simulate a phase error (if safe) to verify
| Symptom | Possible Cause(s) | Corrective Action | | :--- | :--- | :--- | | | - One or more phases missing at input. - Loose connection on L1, L2, or L3 terminal. | Check incoming power with a multimeter. Ensure all three phases are present and correctly terminated at the controller. | | "逆相" (Reverse Phase) LED is ON. | - The phase sequence of the L1, L2, L3 supply is incorrect. | Swap any two of the three phase input wires at the controller's L1, L2, or L3 terminal. For example, swap L1 and L3. | | "过压" or "欠压" LED is ON. | - Supply voltage is outside the preset range. - Voltage threshold may be set incorrectly. | Measure the incoming voltage. Verify voltage is within the unit's rated range. Consult manufacturer documentation for adjusting set points. | | "缺相" (Phase Loss) LED is ON. | - One of the three phases is completely missing. - A severe voltage imbalance (>10%-20%) exists. - Loose connection or faulty fuse upstream. | Check all three supply fuses/breakers. Measure each phase-to-phase voltage. Tighten all connections. A significant imbalance indicates a problem with the supply or transformer. | | Relay chatters or trips randomly for a few seconds. | - Momentary voltage sags or spikes. - Loose wiring in the control circuit. | Check all wiring for tightness. The 7V hysteresis helps prevent this, but if the supply is very noisy, consult the manufacturer for application guidance. | | Equipment starts but then trips immediately. | - The control circuit is wired to the NO contact. - A phase loss or imbalance condition exists. | Verify the control circuit is wired through the NC (Normally Closed) relay contact. Check the "缺相" and "逆相" indicators. |