Manually push the wings to verify they line up perfectly in the center without touching or rubbing against each other. 6. Commissioning and Calibration
This document is an architectural and engineering reference overview. Installation must always be performed in accordance with the specific revision-controlled diagrams, wiring schematics, and safety documentation provided directly by Gunnebo with the specific unit serial numbers.
) for clean, volt-free contact relays (Open Normal, Open Left, Open Right, Fire Alarm Drop). 4. Mechanical Installation and Alignment gunnebo speedstile fl installation manual
Feed the AC mains cable through the designated internal chassis cable management clip.
+---------------------------+ +---------------------------+ | MASTER CABINET | | SLAVE CABINET | | | | | | [Main CPU Board] | | [Slave Drive Board] | | | | | | | | +---[Sync Harness]----+==============>+-----+ | | | (In Conduit) | | +---------------------------+ +---------------------------+ Access Control Integration Manually push the wings to verify they line
Connect the building’s Fire Alarm Control Panel (FACP) to the dedicated emergency input on the Gunnebo board (typically labeled FIRE or EMERGENCY ).
[ MASTER CABINET ] [ SLAVE CABINET ] +------------------------------+ +------------------------------+ | [Main Power Input] | | | | 230V AC / 115V AC | | | | | | | | [Logic Controller] | | | | | | | | [Sync Port]------------------|------------|-[Sync Port] | | | Sync Cable | | | [Fire Alarm Terminal] | | [Motor Drive Connection] | | (Normally Closed - NC) | | | +------------------------------+ +------------------------------+ Mains Power Connection Installation must always be performed in accordance with
This guide provides the general workflow for the Gunnebo SpeedStile FL. For specific dimensional drawings, electrical schematics, and the full Declaration of Conformity (CE Marked according to the EU's Machinery, Low-Voltage, and EMC Directives), the official product manual is required.
Follow these procedures to ensure the units are aligned and secured correctly: Gunnebo SpeedStile FL
Shielded, twisted-pair data cables (typically LiYCY or Cat5e/Cat6 data cables) to link the optical transmitter and receiver arrays across the transit path.