Ultimate Guide to the Hofmann Duolift GTE 2500 Go to product viewer dialog for this item. Manual: Installation, Operation, and Maintenance The Hofmann Duolift GTE 2500 Go to product viewer dialog for this item.
Apply a fresh coat of high-pressure, lithium-based grease or the factory-recommended spindle oil.
Grease the vertical screws immediately; inspect nylon guide sliders inside columns. Broken cable/chain safety switch triggered.
Vigorously nudge the bumper of the vehicle to verify stability on the pads. If stable, resume lifting to the desired working height. Step 5: Lowering the Vehicle hofmann duolift gte 2500 manual
lifting nuts with excellent emergency running properties and roll-hardened, low-wear spindles. Synchronization:
The following specifications are standard for the GTE 2500 model: Rated Load Capacity: 2,500 kg (approx. 5,511 lbs). Maximum Lifting Travel: Lifting Time: Approximately 45 seconds to reach maximum height. Drive System:
The Hofmann Duolift GTE 2500 is an electromechanical two-post lift with a base frame, specifically designed for garages and tire service centers to lift passenger cars and transporters up to a total weight of (2500 kg). Unlike hydraulic lifts that rely on oil and seals, this model utilizes a robust screw thread system driven by a single electric motor. The mechanical drive is transferred from the motorized column to the adjacent column via a durable steel chain housed within the base frame, ensuring perfect synchronization between the two lifting carriages. Ultimate Guide to the Hofmann Duolift GTE 2500
When ordering spare parts, always refer to the specific diagrams in the manual. Common parts for the GTE 2500 include: Lifting nuts (threaded spindle components) Support pads/lifting pads (120 mm) Safety catch mechanisms Drive motors
Freshly poured concrete must cure for at least 28 days before installation.
| Symptom | Probable cause | Corrective action | |---------|----------------|--------------------| | One column lags >10 mm | Wireless interference | Connect sync cable | | Lift stops with error code E-05 | Overload on one column | Redistribute vehicle load | | Column does not respond | Emergency stop activated | Twist emergency stop to reset | | Uneven lowering | Air in hydraulic system | Bleed cylinder (see sec. 6) | Grease the vertical screws immediately; inspect nylon guide
Includes an automatic arm locking system, a chain guide integrated into the base frame, and a chain fracture safety switch.
Verify that the automatic arm locks engage as soon as the arms leave the floor level. Step 4: Lifting the Vehicle Turn the main power switch to the position. Press and hold the UP button on the control column.