Manualadastmaximamh802 !exclusive! 【AUTHENTIC ›】

Lower the knife blade to the cutting stick using the manual maintenance controls.

To ensure longevity and consistent quality, a strict maintenance schedule is required.

from mh802 import MH802 dev = MH802.connect('192.168.1.50') dev.adc.configure(ch=1, range='±10V', rate=10000) dev.start_acquisition(duration=5.0) data = dev.get_data(ch=1) dev.close()

: Unfasten the primary hex bolts securing the blade from the top support arm. manualadastmaximamh802

Fault B: Paper Pile Slides Out of Square During the Down-Stroke : Inadequate hydraulic clamping pressure.

: Carefully lower the dull blade out of the carrier slot and place it immediately into a wooden protective transport box.

According to the factory guide, changing the heavy steel blade is the most critical manual task. Shortcuts risk serious operator injury or severe machine damage. Lower the knife blade to the cutting stick

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Обслуживане Adast Maxima MS80-1 | PDF - Scribd

Dull blades strain the hydraulic system. Replace or sharpen the blade immediately if you notice rough edges or paper pulling.

If you are looking for "Manual" information to fix a problem, consider these common issues with the AA80E: Fault B: Paper Pile Slides Out of Square

The Adast Maxima MH 802 is an 80 cm (31.5 inches) paper cutting machine. It is a hydraulic-clamping guillotine used for cutting piles of paper, board, and similar materials. 800 mm (80 cm) Type: Hydraulic clamp/cutting action Series: Maxima (often MS80-2, MH80-3, or similar variants)

Regularly check and replenish hydraulic fluid and lubricate moving parts according to the technical documentation.

Steps to activate the hydraulic clamp and blade motion. 4. Maintenance and Troubleshooting