Mitutoyo Surftest Sv400: User Manual Full [new]

Press the green START button. Ensure there are no floor vibrations or bumps to the table while the drive unit is moving.

Comprehensive Guide to the Mitutoyo Surftest SV-400 User Manual: Setup, Operation, and Maintenance

Check for signs of jerky travel movements or sticking along the X-axis carriage line.

Because I cannot host a direct file here (as Mitutoyo holds the copyright), here are the for the full PDF: mitutoyo surftest sv400 user manual full

This comprehensive guide serves as an operational manual, covering setup, calibration, measurement procedures, and troubleshooting. 1. System Overview and Component Identification

Check all components, including the display unit, drive unit, stylus, and calibration specimen, against the packing list in the manual.

Select the relevant standard (e.g., ISO 1997, JIS 2001, ANSI). Press the green START button

However, if you are searching for the "Mitutoyo Surftest SV-400 user manual full," you have likely run into two problems: 1) The original paper manual is lost, or 2) You are wrestling with the older DOS-based interface.

Proper physical installation is critical to protect the highly sensitive diamond stylus and ensure measurement repeatability.

Do not rely on memory or outdated cheat sheets. Whether you are performing a simple Ra check on a ground shaft or complex Rmr (bearing ratio) analysis on a mold cavity, keep the adjacent to your workstation. Because I cannot host a direct file here

The diamond stylus is highly fragile. Always raise the Z-axis safely away from the workpiece before removing a part. When not in use, slide the protective plastic stylus cover back on. Troubleshooting Common Issues Probable Cause Corrective Action Noisy or inconsistent data graphs External floor vibrations or air currents.

Periodically check calibration using the standard specimen provided. If results are outside tolerance, recalibrate according to the manual instructions. 5. Troubleshooting (Typical)

A specialized function that guides the user through leveling and tilt adjustment using a tilt adjustment knob.

Always attach the protective plastic stylus cover when the machine is idle. Raise the detector assembly to the top of the Z-axis column to prevent accidental impacts. 7. Troubleshooting Error Codes Symptom / Error Code Probable Cause Corrective Action Over-range Error Stylus displaced past vertical physical limit. Raise the Z-axis immediately; check for surface steps. No Contact Detected Stylus hanging in free space.