Ts1162 Installation Manual Exclusive =link= Jun 2026

Use electrostatic discharge (ESD) wrist straps to protect the sensitive electronics within the TS1162 unit. 2. Unpacking and Component Verification

Configure the specific security areas that this keypad will arm, disarm, or access.

The TS1162 must be connected directly to the Challenger panel's RS-485 LAN. Keep in mind the maximum LAN distance is from the Challenger panel or Intelligent Access Controller. For installations requiring electrical isolation or distances beyond this, use Challenger isolation modules (e.g., TS0893, TS0894, or TS0896). ts1162 installation manual exclusive

Connect a normally open (N.O.) push-button switch directly to the RTE input and the corresponding GND terminal.

Device overview and key components

: Connects via the Challenger RS-485 LAN , supporting distances up to 1.5 km from the main controller.

Network and device configuration

The TS1162 drive operates using standard rack-power distribution units (PDUs), but requires dedicated line conditioning to prevent data corruption during voltage spikes. 100–240 V AC nominal Line Frequency: 50–60 Hz auto-sensing

Disconnect the RTE wires at the TS1162 and short them together momentarily using a jumper. If the door triggers, the issue lies in your cabling or the push-button itself. Use electrostatic discharge (ESD) wrist straps to protect

On the Challenger controller, you must define the keypad's role. This is done via the system's programming software. Refer to the table below for the correct model selection:

I can provide tailored scripts and configuration commands for your exact environment. Share public link The TS1162 must be connected directly to the