While in programming mode, press then "0" then "2" .
The manual emphasizes the following:
If you do not press any keys for 10 seconds while in programming mode, the unit will automatically exit to standby. Entering and Exiting Programming Mode Press * (The LED turns Red). Enter your Master Code (e.g., 999999 ). Press # . V2000-c Rfid Access Control User Manual
You can assign unique User IDs (001 to 999 or higher) to keep track of individual tokens. Enter Programming Mode. Press 1 . Enter a 3-digit or 4-digit (e.g., 001 ) + # . While in programming mode, press then "0" then "2"
Installing and configuring the V2000-C RFID access control system requires careful planning and attention to detail. Here are the general steps involved in installing and configuring the system: Enter your Master Code (e
The V2000-c is a standalone access control keypad that utilizes RFID card technology and a numeric keypad for secure entry. To ensure proper setup, please verify the following technical specifications:
[Current Date] Prepared For: Security System Administrators / End Users Subject: Functional Overview, Installation Guidelines, and Operational Procedures