Wake On Lan Anydesk Hot

When you use the "Wake on LAN AnyDesk hot" functionality, you are utilizing AnyDesk's ability to transmit this packet across your local network to an offline device.

| Problem | Likely Cause | Solution | |--------|--------------|----------| | PC doesn’t wake after sending packet | Fast Startup enabled | Disable Fast Startup in Windows | | WoL works on LAN but not via hotspot | No VPN or port forwarding | Use smart plug or VPN | | AnyDesk shows “Wake up” but not working | Router blocks broadcast | Forward UDP 9 to PC’s IP | | Laptop wakes then sleeps again | Battery settings | Change “Sleep after” to Never on AC | | Mobile hotspot can’t send WoL | Different subnet | Use VPN to bridge networks | wake on lan anydesk hot

Look for settings named Wake on LAN , Power On By PCIE , Resume by PME , or ErP Ready . Set these to Enabled . (Note: If you see "ErP Ready," ensure it is Disabled , as ErP cuts all power to the NIC when shut down). When you use the "Wake on LAN AnyDesk

: Look for terms like "Wake on LAN," "Remote Wake Up," or "Power on by PCI-E" and set them to Enabled . 2. Configure Windows Settings (Note: If you see "ErP Ready," ensure it

Without WoL, your remote PC must stay — wasting electricity, reducing hardware lifespan, and posing security risks. With WoL + AnyDesk:

If your router reassigns your computer's local IP address, the network packet may get lost. Assign a Static IP to your target computer within your router settings.

Windows Fast Startup can prevent Wake on LAN from functioning because it puts the computer into a hybrid hibernation state rather than a standard shutdown. Open the and navigate to Power Options .