In either mode, press the button until the frequency (F) value flashes. Use Up/Down buttons to set the desired frequency.
Set to 0.000 (within the 2-second SET sub-menu). Pulse Number: Set to ---- (Infinite). Execution: Tap ON to start the continuous sequence.
The ZK-PP2K manual highlights two primary modes of operation, which can be toggled by holding the "SET" button for several seconds: zk-pp2k-sterownik-pwm.pdf - gotronik
Automatically preserves all fine-tuned variables and mode selections when power is disconnected. Zk-pp2k Manual
The is a high-power PWM and pulse signal generator capable of driving up to 8A loads (motors, LEDs, solenoids) directly. You can download the full technical paper and manual from Gotronik or Supereyes . ⚙️ Key Technical Specifications
The ZK-PP2K is excellent for high-power LEDs (e.g., 100W COB LED).
Signal output to the device (e.g., driver board, motor controller). In either mode, press the button until the
Example A: Standard DC Motor Speed Regulation (20KHz, 60% Duty Cycle)
Short-press SET to cycle through parameters: P+: Positive pulse width time (seconds). P-: Negative pulse width time (seconds). N: Number of pulses (1-9999, or ---- for infinite). D: Delay time before starting.
description for a certain type of motor or a guide on setting precise pulse counts Pulse Number: Set to ---- (Infinite)
This mode generates a continuous square wave. It controls speed and brightness.
"Ah," Elias said.